So, I was messing around with this “divination 3.5” thing today, and let me tell you, it was a bit of a ride.
Getting Started
First, I needed to actually get my hands on it. I found what I needed. It wasn’t super straightforward, I tell you some steps were a bit confusing at the begining.
The Process
Once I had everything downloaded and installed (which took a bit, not gonna lie), I started playing around. I followed some instructions I found online. Honestly, I spent a good chunk of time just figuring out the basic commands.
- Tried the basic command: I ran the thing with the most basic setup, just to see what would happen. It spit out some, well, interesting results.
- Figured out inputs: Then I spent some time learning what kind of inputs I have to do. It seemed so easy but I’ve made mistakes at the very begining.
- Adjusted parameters: After that, I started messing with the settings. It seems to make difference to get a little improvement, I am just turning the knobs to see where it goes.
- Interpreting the outputs: Made some different inputs and get the outputs.
My Takeaway
After a few hours of tinkering, I finally started to get a feel for it. It’s definitely not something you can just jump into and instantly understand.
I am still confused with some parts of the process but I am also learning so I guess I will master it eventurally.
Anyway, that’s my little adventure with divination 3.5 for today. Might try it again tomorrow, see if I can actually get it to make any sense!
